How do i hook up jumper cables to my car

Contents:


  1. How To Jump Start A Car Battery - Meineke Car Care
  2. How to Jump Start a Car Battery
  3. How to Jump a Car Battery
  4. 1. How To Jump Start A Car Battery The Right Way

Park the functioning car so that the vehicles face each other, preferably only about 18 inches apart, but never touching each other. For automatic transmission cars, put the vehicle in park; for a manual transmission, set the vehicle to neutral. Set the parking brakes on both, so neither car moves unexpectedly. Both cars should be turned off, with keys removed. Set down the jumper cables on the ground, making sure the clamps do not touch each other.

Look at the batteries and make sure that you can identify which is positive, and which is negative. This distinction is crucial to the success of your jump. If the battery terminals are dirty, wipe them off with a rag or wire brush. You want a solid connection to the battery terminal, which may require some initial wiggling of the clamps.

Using Jumper Cables, the Right Way

Walk over to the car with the dead battery. Do not connect the black, negative cable clamp to the dead battery. Instead, attach that clamp to an unpainted, metal part of the car such as a shiny, clean nut on the engine block. This will help ensure a safe jump. Start the working vehicle. Wait a minute or so. Depending on the age of the battery and how long since it died, you may need to let the car run for a minute or two to get the jump to work.

Try starting the dead car. If the car doesn't start, allow the working vehicle to charge the battery for an additional minute or two before attempting again. In some instances, slightly revving the engine of the working car while charging the dead battery may help. Once the dead car is running, you may disconnect the jumper cables, starting with the black, negative cable clamps. Do not let the clamps touch each other while any part of the cables is still attached to a car.

Now, take a short drive. This will allow the battery to build up a charge. If the jump fails to start your car after a few short attempts, or if the car starts but then dies again, you have some other issues you need to address. Most batteries are rated to last years. If your battery is old, you may need to replace it. If the battery should be working well, you should consider other possible problems with other components, including:.

When you do not know what is wrong, your best bet is to take the car in to your local Meineke Car Care Center for service and repair. Dealing with a dead car battery is a pain. Luckily, getting your car working again is not terribly difficult. By following these instructions, using your jumper cables sensibly, practicing safety and addressing other potential concerns, your car will run better, be safer, and last longer.

For professional advice and assistance, talk to your local mechanic at your neighborhood Meineke Car Care Center. But then, the next time you try to start your engine, you experience the same problems—clicks, sputters, all the telltale sign of a dead battery. There are several potential causes to consider. Spending about 20 minutes driving around town is ideal. These are not the only potential causes of your battery woes, but they represent the most likely scenarios.

First, simply turn on your headlights. If they come on with their normal brightness, your problem is probably a bad starter or poor wiring—not the battery itself. Next, test the voltage of your battery. To do this, get a voltmeter and connect the red lead to the positive terminal and the black lead to the negative terminal. From there, consider the condition of the battery itself.

Does it look obviously corroded or worn out? Is it more than four years old? If so, then the simplest solution may be to have the battery replaced. Finally, consider whether the problem is your alternator. First, it may be that the terminals on your car battery need a deep cleaning.

How To Jump Start A Car Battery - Meineke Car Care

Your battery may simply be very old, and beyond the point at which it can be repaired—in which case, of course, it will need to be replaced. Finally, note that there could be another mechanical problem somewhere in the vehicle, such as blown fuses or a bad alternator. A Meineke service technician can help diagnose and fix any of these problems. First and foremost, turn off your engine.


  • ;
  • How to Hook up Jumper Cables: 13 Steps (with Pictures) - wikiHow.
  • .
  • ;
  • .
  • !

While cleaning the terminals is a fairly straightforward DIY project, there is still a slight risk of injury. You can avert this risk simply by making sure you have the engine turned off while you work. Detach the cable from the post. Then, follow the same steps with the positive cable. Take just a moment to visually inspect your car battery. Specifically look for any fissures or cracks. Use the toothbrush to scrub away any signs of corrosion you see on your battery terminals.

You may have to soak your toothbrush in the baking soda mixture a couple of times as you keep scrubbing away. When you finish, use a spray bottle with cool water to rinse off any residue. Always connect the jumper cables directly to the donor battery. Not Helpful 0 Helpful 0. Yes, they can be used as many times as you need them, just as long as there are no bare wires showing. Not Helpful 0 Helpful Depends on engine speed. At idle the voltage input from the alternator is minimal and. An take hours. At highway speed more voltage and charge in 2 hours or so.

Best to recharge using a battery charger overnight then it gets charged all the way to its max. Not Helpful 0 Helpful 6. Should both the donor car and the car with the dead battery remain on for 30 minutes with the cables attached to ensure full charging? No, once the dead car has been jump started, you can disconnect the donor car right away. The dead car just needs help starting the engine.

After that just leave it running idle for minutes, and it will recharge itself via the alternator. Not Helpful 0 Helpful 5. Why does the horn honk when I attach the ground cable to the dead car? As an indicator that the dead battery is being charged. It's a safety feature to ensure mechanics understand what's going on with the flow of the electricity. Not Helpful 1 Helpful 7. No, you should run the car that had the dead battery for a while to ensure that the battery gets fully recharged. If you turn the car off to remove the jumper cables there is a good chance you'll be putting the cables back on to jump it a second time.

Not Helpful 6 Helpful Can I connect the black jumper wire to a dead battery's negative terminal? Walk over to the car with the dead battery. Do not connect the black, negative cable clamp to the dead battery. Instead, attach that clamp to an unpainted, metal part of the car, such as a shiny, clean nut on the engine block. This will help ensure a safe jump.

Not Helpful 3 Helpful 7. Alternators produce more amps at higher RPMs, and more amps means a faster charge rate. Not Helpful 0 Helpful 2.

How to Jump Start a Car Battery

What happens if you put jumper cables on the ground when the car is running? Regardless of whether the car is running or not, jumper cables should never be lying on the ground loose at either end while the other end is connected to a battery. If only the wire portion of the cable is touching the ground, this is acceptable. The article is incorrect in stating that jumper cables are not usually different lengths, this is to prevent the possibility that the ends could touch together and short circuit. Not Helpful 2 Helpful 4.

Include your email address to get a message when this question is answered. Already answered Not a question Bad question Other. By using this service, some information may be shared with YouTube.

How to Jump a Car Battery

How to Hook up Jumper Cables. Article Summary X To hook up jumper cables, park the donor vehicle next to the vehicle with the dead battery, turn both vehicles off, and set the parking brakes.


  • .
  • .
  • .
  • ;

Did this summary help you? Tips Some vehicles have plastic covers over the entire battery you have to remove before attaching the cables. You can remove it by prying it off or unscrewing it. Take a recently-jumped car for at least a 15 minute drive to charge the battery. Some cars have batteries under the rear seat or in the trunk of the car.

These cars may also have a jump port under the hood. Clamp the red jumper cable to it after prying off the cover. Shorter cables tend to work better since the electrical current has less distance to travel. Longer cables can lead to weaker currents and increased charging times. Get a rechargeable battery pack for jump-starts without needing a working car. You keep the battery pack charged through its USB port, then hook the jumper cables to it like you would normally when you have a dead battery. Warnings Avoid jump-starting a frozen battery. If you can open the battery, look to see if the liquid inside of it has frozen.

Car batteries discharge explosive hydrogen gas, so avoid smoking near them. Also make sure the black grounding cable is not attached to the negative terminal on the dead battery. Article Info This article was co-authored by Andrew Everett. Did this article help you? Cookies make wikiHow better.

By continuing to use our site, you agree to our cookie policy. This is the first time that I have finally reached out to the how-to aspect and have been so fortunate to find such a detailed clear directions on wikiHow. AA Allysa Albright Aug 3, It made it easy to understand and implement, even for a girl that hates to get her hands dirty.

1. How To Jump Start A Car Battery The Right Way

Mari Jun 17, Came out of my office to a dead battery. The pics made it super easy to follow! RP Robin Price May 23, The instructions are very clear and walked me right through another new experience! TK Teresa Kocher Oct 5, I did have to connect charger on top post all of it, differently than from my side post battery.

Page Sep 9, I always got confused about which car I should disconnect first. This cleared it up for me. CW Cindy Winter Jul 14, SA Stacy Adams Apr 14, This was my first time using jumper cables. EF Emma Fahrner Jun 8,